胶桶,压力桶
发布时间 2006-06-17 11:09:24
产品描述
压力桶
桶盖为整铝加工而成，强度高，密封性好，不粘胶,使用方便,容易清洗。
注意事项
1． 不可随意调整保险阀；
2． 新胶桶使用前，要把不锈钢内桶用甲笨清洗干净然后再放入胶水；
3． 胶桶中胶水不能加得太满，以防胶水倒流入气管，造成胶机失灵；
4． 盖上桶盖，然后均匀锁紧“十”字螺帽；
5． 拉出调压阀旋钮，将气压调节到适当的范围（一般为0.1-0.7(Mpa)），然后将调压阀旋钮压回去即可。
Tank
The barrelhead made of entire aluminum processing,
intensity high, the leak-proof quality is good, not viscose, Easy
to operate, Easy to clean.
Note:
1． Don’t adjust the safety valve.
because when exceed safe pressure range no ensure to release
the pressure；
2． Before use the new glue
barrel, the stainless steel In-barrel must be clean in
with the armor stupid then put in glue water again
3． In the glue barrel the glue
water cannot add too completely, Avoidable the glue water to flow
in the trachea ,Create the rubber machine to
malfunction;
4． Covers the Tank, then locking
"*" screw cap
5． Pulls out the adjust
pressure valve knob, adjusts the pressure get the suitable
range ( generally 4-6kg), then turn back adjust pressure valve
knob.
天豪点胶,天豪科技
进入店铺
在线留言
| 联系人 | 王小姐 |
|---|---|
| 联系电话 | 0086-574-63688105 0086-13685884044 |
| 地址 | 慈溪市天豪电子科技有限公司 |
| 邮箱 | trade@tianhao-auto.com |