摆线液压马达原理
发布时间 2023-11-13 13:04:18
产品描述
| 适用范围 | 机械 |
|---|---|
| 外形尺寸 | 圆形 |
| 产品用途 | 驱动 |
| 性能参数 | 摆线液压马达订购热线：13792343699 |
结构特点
LMS马达是一种端面配流马达。其结构特点：
?先进的端面配流设计,低速转动平稳。
?先进的轴密封设计，能承受高背压。
?先进的配油机构设计, 具有磨损自动补偿功能。
?双列圆锥滚子轴承设计能够承受较大的径向力。
?多种法兰、输出轴、等安装连接形式。
LMS motor is a disc
valve type gerolor motor.
Characteristic features：
?Advanced
design in disc distribution flow, which can provide improved
performance at low speed.
?Advanced design of
shaft seal, which can bear higher pressure.
?Advanced distribution mechanism design, which has the automatic compensation
function.
?Double-rolling bearing design, which permit higher radial loads.
?A variety of connection types of flange; Rabbet:, output shaft
and oil port.
主要性能参数 Main Specification
1.**大压力指入口**大压力，连续工作压力指工作压差.
2.马达不能同时在**高压力和**大转速下工作.
3.在断续工作条件下，运行时间每分钟不能超过10%.
4.推荐用68#抗磨液压油，粘度37-73cSt，清洁度ISO18/13
5.**高工作油温80°
6.马达满负荷工作前，应在**高工作压力的40%以下磨合1h.
7.马达允许**大背压10MPa，但推荐不要超过5MPa，超过时应接外泄油管.
1. Intermittent means the
entrance of the maximum pressure; continuous working pressure means
the differential pressure
2. Motor should not work under
the highest pressure and the maximum speed
3. The running time should not
exceed 10% under intermittent working conditions
4. Recommending N68 anti-wear
hydraulic oil, viscosity 37-73cSt, cleanliness
ISO18/13.
5. The Maximum working
temperature is 80 °
6. One hour running time under
40% of maximum working pressure is recommended before full capacity
working.
7. The maximum allowable back
pressure is 10MPa, but the recommended back pressure should not
exceed 5MPa.a leaking pipes isneeded when exceeding