●用途 Application
   JXL系列契型线夹适用架空配电线路中导线的非成立接续，适用于架空绝缘铝绞线和钢芯铝绞线，绝缘罩和线夹配套使用，起绝缘防护作用。
   JXL series clamp（wedge type）is suitabic for unendre force splicing of onductor on the aerial distribution,also used for aluminium wire or aerizl insulation aluminum core wire,insulation cover and clamp are used together.lt’s action is insulation protection.

1、产品的独特设计及线沟内涂有抗氧导电膏，大大提高了线夹的过载能力和热循环能力，可有效地降低线损节能增效，并使因线夹接触不良而引发的线路故障率降至“零”；
2、操作非常简单大大降低施工劳动强度；
3、额定扭断力螺杆保证所有产品安装品质相同，完全避免了安装中人为因素对安装质量的影响；
4、C形件的弹性作用，可以补偿导线的应力松弛，使线夹在任何环境中与导线都行成有机的整体；
5、螺杆在安装到位后保持恒定拉力可起到保险定位作用；
6、适用本产品能提升整个线路的运行质量。

1.Its unique design features and the application of anti-oxidant conductive paste within the cable channel can signigicantly improve the ability for overloading and heat cycle,remarkably decrease the line loss and increase the energy conservation and efficiency,and reduce to "zero" the line failure rate caused by the bad contact of clamps;
2.It’s very simple to operate,thus bringing an enormous reduction in the construction and labor intensity;
3.The rated anti-torsion bolt can guarantee the uniform installation quality for all products and remove all the adverse influence due to human factors on the installation quality;
4.The flexibility of C form parts can supplement the stress looseness of wires,makiing clips and wires an integrated combination under any
5.circumtance.The installed bolts can maintain the constant tension to safeguard the fixed position.
6.Using this Product can enhance the operating quality of the whole line.

 

●安装说明 Installation explain

1、剥离绝缘导线绝缘层，剥离长度应大于线夹长度5厘米，将C形元件和分接线一起挂在主线上，将楔块用力插入两导线之间。

2、将**螺栓插入C形无件预留孔与楔块的螺纹孔相连，用套筒扳手拧紧螺栓直到**个螺帽自行断落。

3、将线夹和绝缘导线多剥离部分用绝缘自粘带缠绕好，或使用线夹罩将线夹保护起来。

1、Skin the insulation material of wires with a length 5 cm more than that of wire clip, and hang C form parts and splitting wire on the main cable ,and then ｉｎｓｅｒｔ the wedge between the two wires with force .

2、Insert special bolt into the preset hole of C form parts ,where the bolt will be fixed into the threaded hole of wedge ,then screw the bolt on with a socket spanner until the first nut drops .

3、Use insulation tape to wrap the over-skimmed sections of clips and wires ,or protect the wire clips with clip covers .

●JXL型线夹选用表 Selection list